Description

When running GUI scripting, the successful cells are being coloured in Orange rather than no colour. I then need to remove the colour from these and "run on errors" for the failures in order to catch the actual failures and once reprocessed the colour of the cell remains Orange, even if the transaction was successful. 

It has only started happening since I upgraded to Studio 12?

Applies To

11x;12x

Solution/Immediate Workaround

Perform the below steps to debug the issue

1) Check the flag "Technical log Information" (see screenshot attached) in the Mapper.

2) Rerun the  scenario
a) If in the log message the message starts with "E:XXXX" but still the correct message then it is SAP Limitation we can not amend it ; it means this is the message SAP is providing and we can not make any changes as this is SAP configuration.

b) If you get "S:XXX" then I will need to check from Winshuttle Support Team.

Addition Information

Work with Engineering if Success message.